M-F 7:30 am - 4:30 pm

No products in the cart.


Step by Step Instructions

Step 1

With a Philips head screwdriver, remove side screw from air shutter assembly and using two wrenches, remove orifice/shutter from flex line as shown.

[vc_table vc_table_theme=”classic” el_class=”table_inner_volu”][c#dbdbdb],,[b;14px;align-center]Orifice%20Sizing%20Chart,|[14px;b;align-center]Burner,[14px;b;align-center]Natural%20Gas,[14px;b;align-center;]Propane%20(20lb),[14px;b;align-center]Propane%20(whole%20house)|CF1224,[align-center]%2331,[align-center]%2343,[align-center]-|CF2424,[align-center]%2317,[align-center]%2343,[align-center]%2336|CF1242,[align-center]%2321,[align-center]%2343,[align-center]%2331[/vc_table]

Step 2

Unscrew orifice from air shutter and replace with the supplied orifice (refer to chart for proper orifice for your burner) for natural gas. Make sure air shutter is CLOSED so that the screen is not showing before tightening side screw. Use two wrenches to securely tighten orifice.

Step 3

Ensure gas valve on the fire pit table is in the OFF position before this step. On the back side of the control panel, replace incoming propane hose with included incoming natural gas line and securely tighten.

Ensure that all connections are fully tightened and checked for leaks before operating this fire pit.

Air shutter assembly
Unscrewing orifice from air shutter
Gas valve closeup